203729
Rev. E, 11/20/18
© 2018, THE STANLEY WORKS. ALL RIGHTS RESERVED.
9 of 18
3.7
Installing
the Weatherstripping
3.7.1
CLEAN edges of the O & SX panels using glass cleaner. CLEAN exterior surface of
the lead SX shoes & trail edge O shoes.
3.7.2
Refer to Figure 7 and PRESS pressure-sensative gray pile with clear PVC housing
onto the leading edges of the SX panels. Peel the adhesive liner from the inner
channel as needed.
3.7.3
Refer to Figure 7 and PRESS pressure-sensative gray pile with clear PVC housing
onto the trailing edges of the O panels. Peel the adhesive liner from the inner channel
as needed.
3.7.4
With brush facing the
exterior
of the building, INSTALL 90° clear extrusion with
weatherstripping onto
leading
edge of O panels.
3.7.5
With brush facing the
interior
of the building, INSTALL 90° clear extrusion with
weatherstripping onto
trailing
edge of SX panels.
3.7.6
Locate the gray self-adhesive pile from the hardware kit and cut to length. Peel the
self-adhesive backing and PRESS on the pile to the lead edges of the SX shoes.
ALIGN the pile so it contacts each other when the panels are in the closed position.
ENSURE the pile does not prevent the panels from closing properly.
Figure 6. Hanging the SX Panel on the Header Track
