203729
Rev. E, 11/20/18
© 2018, THE STANLEY WORKS. ALL RIGHTS RESERVED.
8 of 18
3.6.4
Using an Allen wrench SET the load wheels to the midrange of travel position in the
hanger. In this position, the top of the load wheel is
1
/
16
″
below the top of the hanger.
3.6.5
SET the anti-riser wheels so that the top of each wheel is flush with the top of the
hanger.
3.6.6
TIGHTEN the nuts securing the load wheels and anti-riser wheels to the hanger.
3.6.7
Refer to Figure 6, and INSTALL the bottom guide to the SX panel bottom rail.
WARNING
Whenever the door anti-riser wheels are not set, there is a possibility that the panel could fall off the hanger
track. Use extreme caution when handling the panels.
3.6.8
Refer to Figure 7, and INSERT the SX panel bottom guide into the O panel bottom
rail.
3.6.9
Carefully LIFT the SX panel and POSITION the panel onto the header track.
3.6.10
SET the anti-riser wheels so that there is a 1/64
″
to 1/32
″
gap between the top of each
wheel and the track.
3.6.11
REPEAT Section 3.6 for the opposite SX panel.
Figure 5. Setting the Load Wheels and Anti-Riser Wheels
