7
OPERATION
The unit can be operated either by the switches located on the RHS of the unit or using the remote control sup-
plied. For the unit to operate, the ON/OFF switch, located on the underside of the canopy must be switched to
the “I” position.
NOTE:
The unit may emit a slight, harmless odour and smoke when first used. This odour & smoke is normal
and it is caused by the internal heating of the internal heater parts and will not occur again.
MANUAL OPERATION
1.
Press the Power button to start the flame
picture and the current room temperature will
be shown on the display.
2.
Adjust the temperature to the desired setting
(15° to 30°C Range) using the Temp + &
Temp - buttons - See Fig 3.
NOTE:
The set temperature must be above
the room temperature for the heating
function to operate.
3.
Press the Heater button to select Full Heat
(2kW) and H2 with the red flame symbol
will be displayed - see Fig 4.
4.
Press the Heater button again to select Half
Heat (1kW) and H1 with the orange flame
symbol will be displayed - see Fig 5.
On either heat setting, the heat function will turn off
when the room temperature reaches the set temper-
ature. The heat function will automatically restart
when the room temperature drops 3°C below the set
temperature.
5.
Press the Heater button again to turn off the
Heater function.
NOTE:
The fan will run for approximately 30
seconds after the Heating function is
turned off to remove any residual
heat for the unit to protect the control
components from any potential
overheating.
Fig 3
Fig 4
Fig 5
