![ST&G 1315S Скачать руководство пользователя страница 10](http://html.mh-extra.com/html/standg/1315s/1315s_instructions-manual_1356257010.webp)
Apply Masking tape over the whole area to enable a
smooth and relatively flat blended in surface – if the
rivet sticks through the tape, that is ok. You want to
be sure that the Star Nut is completely covered so it
stays in place when the hole is either chased, or
drilled and tapped.
After Star Nut bonding has cured:
If Star Nut is threaded, burnish a through hole, and
chase the threads with a 4mm metric tap.
If not threaded, burnish a through hole, re-drill a
clean hole, and tap with a 4mm metric tap.
Apply thread locker to the stud threads, and screw
the stud into the hole and into the Star Nut.
After determining the length needed for the cable,
run through the lanyard handle.
NOTE: Cable can be run through a housing.
NOTE: Lanyard handle may vary depending on
knee model used!
After the length is established, insert the handle so
the pull tabs are on the distal aspect when inserted
onto the stud.
NOTE: Do not tighten set screw completely in
case length needs to be adjusted!
Once length is established, the set screw(s) can be
tightened down.
NOTE: Be sure to leave some extra cable in
case some length adjustment may need to be
done at a later time!
NOTE: Be sure knee lock can cycle adequately
before delivering to your patient.