Standen ZENO 21, Руководство пользователя

Страница: 17 / 65

Tipping Hopper
The rear section of the tipping hopper (item 1, fig 8) is designed to gently feed the
potatoes into the hopper belts. Sensors can be fitted inside the hopper to detect the
level of seed above the hopper belt feed area. On automatic mode the sensors raise
the rear section of the hopper automatically.
The stays (item 2, fig 8) are provided to lock the hydraulic rams (item 3, fig 8) in the
open position when working under the hopper. The hopper should be empty when
performing this operation.
WARNING: Always lock the raised hopper with the stays (item 2,
fig 8) before working underneath.
To lock the hopper in the raised position:
1.
Raise the hopper fully.
2.
Remove the pin (item 4, fig 8) and lower the stay (item 2, fig 8) down over the
piston rod (item 5, fig 8).
3.
Insert the pin (item 4, fig 8) into the hole (marked A) fitting it under the piston
rod and secure it with the ‘R’ clip.
Always unlock and reset the stays (item 2, fig 8) before lowering
the hopper. Failure to observe this caution may cause serious
damage to the machine.
OPERATION 1.12
Fig 8