Standard Horizon Matrix GX3000E, Руководство по обслуживанию

Страница: 14 / 66

14
Alignment
Software Alignment/Confirmation Mode
The “Software Alignment/Confirmation Mode” has been
build in the microprocessor in order to adjust and con-
firm the performance of transceiver.
The purpose is to adjust transceiver simply and to con-
firm the performance of transceiver smoothly.
S
TARTING
S
OFTWARE
A
LIGNMENT
M
ODE

Confirm that the transceiver’s power is turned off.

Short the TEST points (JP1001).

Press and hold the VOL/PWR knob until the radio
turns on while press and holding the [ CALL
(
MENU
)]
and [ DISTRESS
] keys. The LCD
will be as shown in the illustration
at the right.
Squelch Adjustment

Setup the test equipment as shown below.
S
TARTING
S
OFTWARE
C
ONFIRMATION
M
ODE

Confirm that the transceiver’s power is turned off.

Short the TEST points (JP1001).

Press and hold the VOL/PWR knob until the radio
turns on while press and holding the [ DW
(
IC
)] and
[
DISTRESS
] keys. Release the
keys, the LCD will be as shown for
one second in the illustration at the
right.
DSC Encoder Confirmation

Setup the test equipment as shown below.

Press the [ SCAN
(
MEM
)] key to re-
call the Alignment Item “
04: 04:
04: 04:
04:
THRESHOLD THRESHOLD THRESHOLD THRESHOLD THRESHOLD
.”

Set the RF Signal Generator output to 156.800 MHz,
at a level of –10 dB
μ V, ±3.0 kHz deviation with a 1
kHz audio tone.

Press the [ DW
(
IC
)] key.

Press the [ ENT
] key to save the new setting.

Press the [ SCAN
(
MEM
)] key to re-
call the Alignment Item “
05: TIGHT 05: TIGHT
05: TIGHT 05: TIGHT
05: TIGHT
.”

Set the RF Signal Generator output
to 156.800 MHz, at a level of +2 dB
μ ±3.0 kHz devia-
tion with a 1 kHz audio tone.

Press the [ DW
(
IC
)] key.

Press the [ ENT
] key to save the new setting.

Press the [ SCAN
(
MEM
)] key to re-
call the Alignment Item “
07: DC 07: DC 07: DC 07: DC 07: DC
VOLT VOLT VOLT VOLT VOLT
.”

Set the DC Power Supply to 13.8 V.

Press the [ DW
(
IC
)] key.

Press the [ ENT
] key to save the new setting.
This completes the Software Alignment Mode. To save
all settings and exit, press and hold the [
DISTRESS
] key
for 2 seconds.

Set the channel to CH70.

Press the PTT switch, confirm that the first tone de-
viation is 4.2 kHz ±0.3 kHz.
Note : In CH70 while Software Confirmation Mode,
ever time you are in transmit mode, (every time you
press PTT), the following test tone can be outputted:
1st transmission: Synthetic tone of 1300 Hz and 2100 Hz
2nd transmission: 1300 Hz
3rd transmission: 2100 Hz
4th transmission: No Modulation
5th transmission: Return to 1st transmission
This completes the Software Alignment/Confirmation
Mode. Turn the transceiver’s power off, then disconnect
the Jumper from the TEST points (JP1001).
RF Signal
Generator
ANT
GX3000S/E
Deviation
Meter
50-ohm
Dummy Load
Sampling
Coupler
ANT
GX3000S/E