HX760S
Page 20
6. BASIC OPERATION
6.1 PROHIBITED COMMUNICATIONS
The FCC prohibits the following communications:
y
False distress or emergency messages:
y
Messages to “any boat” except in emergencies and radio tests;
y
Messages to or from a vessel on land;
y
Transmission while on land;
y
Obscene, indecent, or profane language (potential fine of $10,000).
6.2 INITIAL SETUP
1. Install the battery pack on the transceiver (see section “
4.1.2 BATTERY
INSTALLATION/REMOVAL
”).
2. Install the antenna onto the transceiver; hold the bottom end of the an-
tenna, the screw it onto the mating connector on the transceiver until it is
snug. Do not over-tighten.
NOTE
Water resistance of the transceiver is assured only when the battery
pack is attached to the transceiver and
MIC/SP
cap is installed in the
MIC/SP
jack.
6.3 RECEPTION
1. Press and hold the [
POWER
( )] key for two seconds to
turn the transceiver on. The DC supply voltage will be
indicated on the display for 2 seconds.
2. Press the [
SQL
] key to activate the squelch adjusting
mode. Press the [
T
] key until the SQL level is “00”, then
press the [
SQL
] key again (or wait 3 seconds to exit from
the squelch adjusting mode). This state is known as
“Squelch Off”.
3. Press the [
VOL
] key to activate the volume adjusting
mode. Press the [
T
]/[
S
] key until the noise or audio from
the speaker is at a comfortable level, then press the [
VOL
]
key again (or wait 3 seconds to exit from the volume ad-
justing mode).
4. Press the [
SQL
] key, then press the [
S
] key until the
random noise disappears. This state is known as the
“Squelch Threshold”.
5. Press the [
T
] or [
S
] key to select the desired channel.
Refer to the channel chart on page 42 for available chan-
nels.