Standard Horizon HX400, Руководство пользователя

Страница: 24 / 48

HX400 Page 24
6.8 MEMORY SCAN
The HX400 will automatically scan channels programmed into Preset Channel
Memory and also channels store into Scan Memory.
When an incoming signal is detected on one of the channels during scan, the
radio will pause on that channel, allowing you to listen to the incoming trans-
mission. The radio will automatically start scanning again after the transmis-
sion stops.
6.8.1 PROGRAMMING SCAN MEMORY
1. Turn the transceiver off by rotating the VOL knob fully counter-clockwise.
2. Hold down the key, and then turn on the transceiver while still holding
down the key.
3. Press the or key to select “ MEM CH ” and press
the key.
4. Press the or key to select desired channel to be
scanned, then press the key. The “ ” icon ap-
pears on the display, which indicates the channel has
been selected to the scan channel.
5. Repeat step 4 for all the desired channels to be pro-
grammed into scan memory.
6. To DELETE a channel from the list, select the channel
then press the key. The “ ” icon disappears from
the display.
7. When you have completed programming the scan
memory, press the key to save your changes, and
then press the key to exit to normal operation.
6.8.2 OPERATION
1. Press the key to activate the squelch adjusting mode, then press the
/ key until the background noise disappears.
2. Press the key to start scanning channels pro-
grammed into memory and preset channels. “
MSCAN
”
will be shown in the upper left corner of the display.
3. When the HX400 receives a transmission, it will stop
on the channel until the incoming signal disappears,
then start scanning again.
4. To stop scanning, press the key.