DS35 User Manual
9
5 Operation
5.1 Primary Operation
5.1.1 Setting Unit of Measure
To select the unit of measure, press and hold the
key for three seconds. The display changes.
Depth can be displayed in feet, meters, or fathoms.
If the water depth is greater than 200 feet or if too
much aerated water is passing over the transducer
(refer to sections 4.2.2, 4.2.3, 4.2.4), the numeric
section of the display will show two horizontal lines.
Press and hold
for 3 seconds
Press and hold
for 3 seconds
Press and hold
for 3 seconds
5.1.2 Setting Shallow Alarm
Press and hold both the
keys for three
seconds to enable the alarm mode. Press the
key to select the shallow alarm. “LO” displays
momentarily. Press either the
or
key
to change the setting. Press the
key to exit
to normal operation. Or to disable the shallow alarm,
press the
key until the display decreases to
“OFF”.
Press and hold
for 3 seconds
Display alternates
between these two
Press to set
Shallow Alarm
Press to set
Alarm Depth
or
Press until
display
decreases to
OFF
or
Press to exit
Depth Display
Press to exit
Depth Display
