OPERATIONAL INSTRUCTIONS
WOODEN BARRE ADJUSTMENT
To adjust the height of the
WOODEN BARRE(13).
Turn
the
SPRING PINS(12)
on the
LEFT
and
RIGHT SLIDERS
(8, 10)
counter clockwise until the knob portion can be
pulled. Pull both
SPRING PINS(12)
at the same time and
slide the
SLIDERS(8, 10)
up or down to adjust. Release
the
SPRING PINS(12)
to lock the
SLIDERS(8, 10)
in the
desired adjustment holes. Rotate the
SPRING PINS(12)
clockwise to lock the
SLIDERS(8, 10)
securely.
NOTE:
Always make sure that the
SLIDERS(8,10)
are adjusted
so the barre is parallel with the mat.
10
MAINTENANCE
The safety and integrity designed into the
Studio Tower
can only be maintained when the
Studio Tower
is regularly examined for damage and wear. Special attention should be given to the following:
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components should be replaced immediately or the
Studio Tower
removed from
service until repair is made.
Verify that the
WARNING LABEL(63)
is present and legible. Replace the
WARNING LABEL(63)
if it is
missing or damaged.
Inspect the
WOODEN BARRE(13)
for cracks or other damage. Replace the
WOODEN BARRE(13)
if it
is damaged.
Check the condition of the
SAFETY STRAP(37).
Replace the strap if damaged or worn.
Check the condition of the
SPRINGS(34, 35, 36).
Replace the springs that are damaged.
Check the
HAND STRAPS(21)
for damage. Replace damaged parts.
Check the
FOAM SLEEVE(29),
and
SPRING SLEEVE(33)
and replace if damaged or worn.
Check the
CUSHIONS(2, 4, 6)
and replace if it is damaged or worn.
Only Stamina Products supplied components shall be used to maintain/repair the
Studio Tower .
Keep your
Studio Tower
clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
Содержание Studio Tower Combination Unit
Страница 16: ...PRODUCT PARTS DRAWING BACK FRONT 16 ...
