TREADMILL ADJUSTMENTS
WALKING RESISTANCE
The walking resistance or effort needed to push the treadmill belt can be adjusted by changing the incline
angle. This treadmill has two adjustment positions.
Lowest Resistance
Remove (unscrew) the
BUMPER STANDS(22)
from the bottom of the treadmill and store them
in the end of the treadmill.
Highest Resistance
The
BUMPER STANDS(22)
are attached to
the bottom of the treadmill.
Since this is a new ma chine, you may need some ti me to get used to wal king on the tre admill and to
break it in.
If the walking resistance is still too high, check the
BELT TENSION.
The belt resistance can be reduced by adding silicone lubricant between the belt and the board. Wipe
the board under the belt with a cloth and spray or spread silicone lubricant on the board under the belt.
Clean the exposed surfaces of the walking belt and the board with an absorbent cloth.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Verify that the Spring Pin is pre sent and functioning properly . Verify that the Ball Knob is se curely
attached to the Spring pin. Repair or replace parts as necessary.
Verify that all nuts and bolts are present and properly tightened. Replace missing nuts and bolts. Tighten
loose nuts and bolts.
Verify that the Warning La bel is in pla ce and e asy to re ad. Call Sta mina Products i mmediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
Worn or damaged components shall be replaced immediately or the
InMotion
TM
II Treadmill
removed
from service until repair is made.
Only Stamina Products supplied components shall be used to maintain/re pair the
InMotion
TM
II
Treadmill.
Keep your
InMotion
TM
II Treadmill
clean by wiping with an absorbent cloth after use.
If the
WALKING BELT(17)
does not move e asily, lubricate the
BOARD(18)
under the
WALKING
BELT(17)
with Silicone Lubricant.
1.
2.
3.
4.
5.
6.
7.
8.
9.
MAINTENANCE
The safety a nd integrity de signed into the
InMotion
TM
II T readmill
can only be maintained when the
InMotion
TM
II Treadmill
is regularly examined for damage and wear. Special attention should be given to
the following:
NOTE:
1.
2.
3.
10
Meijer.com
