5
STALGAST Radom sp. z o.o. ul. Staniewicka 5 03-310 Warsaw
tel.: 22 517 15 75 fax.: 22 517 15 77 www.stalgast.com email: [email protected]
4.
DESIGN FEATURES OF THE DEVICE
Figure
1
On/Off
Indicator light for
boiler heater
Wash cycle
Indicator light for
chamber heater
Figure
2
5.
INSTALLATION
I.
Connection to power sources
Connecting the appliance to the mains can only be carried out by the technical service personnel in accordance
with applicable law. The electrical parameters of the appliance are included in the table in section 3. It is
forbidden to make one electrical safeguard for two appliances. It is necessary to install a main circuit breaker
and an earth fault breaker.
Both switches must be installed in an easily accessible location in such a way as to guarantee disconnecting the
appliance from power supply in accordance with the category II.
The appliance is fully disconnected from the power supply only when the main switch is set to OFF. The
appliance must be connected via the terminal placed in the rear, lower part of the appliance. Protective earth
(PE) is marked in yellow-green, neutral (N) in blue, and the phase conductor (L1) is marked in black.
II.
Connecting the appliance to the water mains
Water hoses and the power cord are protruding from the rear. The water supply hose must be connected to a
¾" outlet. The connection should be closed only with the use of a brand new hose. In order to observe safety,
water pressure should be between 2-4 bar. Should the pressure be higher, a pressure reducer should be
installed. The main valve should be installed above the hose feeding water into the appliance. The main valve
should be installed in an easily accessible location; therefore it should not be installed behind the appliance. The
duration of the cycle is given for the supply water temperature of 50°C. When the appliance is connected to
cold water, the duration of the cycle may be increased, because the appliance is equipped with a constant
temperature pressure rinsing system.
III.
Drain hole
The appliance is equipped with a drain pipe, which should be installed at floor level with the use of a vent.
