Stalgast 773025, Инструкция по эксплуатации

Страница: 20 / 22

- 20 -
EN
7. ADDITIONAL INFORMATION
7.1. UTENSILS THAT MAY BE USED WITH THE INDUCTION EQUIPMENT:
•
Steel
•
Cast iron
•
Enameled iron
•
Stainless steel marked with
•
The cookware should have a flat bottom (not for the wok appliance) with the dimensions of 12 to 28
cm (stove), 12 to 32 cm for the model 773025 and up to 38 cm for the model 773028
7.2. UTENSILS THAT MAY NOT BE USED WITH THE INDUCTION EQUIPMENT:
•
Heat-resistant glass
•
Copper
•
Aluminum
•
Ceramic dishes
•
Utensils with a rounded bottom (not for the wok appliance)
•
Utensils with bottom dimensions less than 12 cm (not for the wok appliance).
CAUTION!
Do not move the appliance when the power cord is plugged into an outlet, the temperature of
the glass hobs is above 40°C, or when there are utensils on the hobs.
8. MAINTENANCE
Daily maintenance
involves the removal of all pots and pans from the device and washing the components
of the cooker using a cloth dampened in water with a dish washing liquid and then wiping them dry with
a clean cloth. Check the condition of the ceramic glass and the knobs and switches on which the knobs
are mounted daily. Detected damage eliminate the glass and/or the entire appliance from service - please
report this problem to the service.
Once a month,
please check whether:
•
the condition of the appliance’s electrical system is correct (the cord is not damaged, the glass does not
show signs of cracks, etc.).
•
all the components of the device are working properly.
Once a year the device should be inspected by the technical service in order to check the degree of wear
and to identify possible faults of the components and parts of the device.
In case any faults are detected, they have to be removed by qualified technical personnel (technical service).
Monthly maintenance, annual service and repair of the device should only be carried out by qualified
technical personnel (technical service).
9. LIST OF ERRORS
Code Description of the error Solution
L
Surge protection, supply voltage is
lower than 340V
Check if the power supply is correct; if it is, the main
circuit board is damaged
H
Surge protection, supply voltage is
higher than 340V
P
Excessive output power, surze
protection
Use an ammeter to check if the output power isn’t too
high; if so, reduce the power of the device.
F
Short-circuit protection of the
induction coil
Check whether the induction coil is damaged, causing
a short-circuit or water penetration