6
8
Model No.
6
8
Model No.
TM
ERG4007 COMFORT CRIMP
®
COMPRESSION TOOL WITH SHURE STAKE
®
MECHANISM
For Installing 8 and 6 AWG RD, RDV, RE, and REV
Insulated Terminals (Tubular Style Only)
IMPORTANT:
Read and understand all of the instructions and safety
information in this manual before operating or servicing this tool.
In the event the SHURE STAKE
®
MECHANISM must be released, please see Figure 5.
TA04532 A Page 1 of 2
1. Open handles fully.
2. Insure lower die is in the
proper position for the
terminal being installed.
3. Position terminal in the
rear nest. Tongue markings
should be facing up.
4. Close the handles slightly to
secure the terminal. Do not
deform the terminal.
5. Insert stripped wire.
6. Close handles until SHURE
STAKE
®
mechanism cycle
has been completed.
1.2
Figure 3
Figure 2
1.1
1.0
INSTRUCTIONS FOR USE
TO REMOVE:
1. Open handles fully.
2. Use your thumb, push lower
die up and out of jaw.
TO INSTALL:
1. Place die in lower jaw.
2.
Using finger pressure,
snap, lower die down
into position.
To Rotate Lower Die
WARNING
HANDLES ARE NON-INSULATING.
DO NOT CRIMP ON HOT ENERGIZED WIRES
.
WARNING
KEEP ALL BODY PARTS AWAY FROM DIE NEST
DURING GAGING OR CRIMPING PROCEDURE.
Figure 1
For Use With Insulated
Terminals 8, 6 AWG
NOTE:
Do not close handles of the
tool to insert lower die. Use finger
pressure only.
