Assembly Manual
11
Assembly
Step 9: Attaching handrails
Tools
• 5/32" or 4mm T-handle
NOTE:
This Step requires 2 people to complete Steps
9-1 through 10-2.
9-1
With the assistance of another person, tip the SC
916
forward and hold in place while completing Steps
9-2 throught 9-5.
9-2
Remove the 2 rear leg levelers (see Figure 15).
9-3
Take hold of one of the handrails and slide the upper
end into the lower part of the handlebar weldment
and line up the screw holes (see Figure 16).
9-4
Loosely attach the supplied Hex screw to the upper
handrail/handlebar weldment junction using the
5/32" (4mm) T-handle (see Figure 17).
9-5
Position the lower end of the handrail over the rear
leg weldment, then pulling the handrail towards you
secure it into position with 2 Hex screws using the
5/32" (4mm) T-handle (see Figure 18).
9-6
Tighten the Hex screw in Step 9-4.
9-7
Repeat Steps 9-1 through 9-6 on the opposite side.
Figure 17
Figure 16
Figure 18
Screw Hole
Screw Hole
Figure 15
