Stahl 8562/54-246 Series, Руководство по эксплуатации

Страница: 26 / 30

149915 / 8562606300
2012-08-16·BA00·III·en·06
Commissioning
11
Residual current circuit-breaker with
integral overcurrent protection
8562/5
8.3 Connection diagrams
Connect the device according to the rating plate. It has to be taken care that the neutral
conductor is connected correctly.
9 Commissioning
Before commissioning, ensure that:
 the device has been installed in accordance with the standards,
 the connections have been correctly made,
 the device is not damaged,
 all screws and nuts are fully tightened.
10 Maintenance
10.1 Maintenance
Function test of FI switches/circuit breakers

For function testing in the on-state, press the test key “T“. The FI switch/circuit breaker
must be triggered immediately.
Circuit diagrams
07606E00 07621E00
1-pole+N 2-pole
11536E00 15104E00
Auxiliary contact 1 W Auxiliary contact 2 W
*)
07618E00
12218E00
12219E00
12469E00
Fault signalling contact
1 W with reset

function for fault signal
Auxiliary contact 1 S

Fault signalling

contact 1 S
Auxiliary contact1 W

Fault signalling
contact1 W
Connecting relay

Auxiliary contact 1 S
*) only for types 8562/54-2465-160-4 and 8562/54-2475-160-4: After the circuit breaker has been activated,

the fault-contact can be reset manually.
Maintenance and repair work on the devicess may only be carried out by appropriately
authorized and trained personnel.
Before any work commences, the devices must be disconnected from the supply.
96
95
98
91 95
9 4 98 92 96
06
05
08
05
08 98
95
05 95
08 98 06 96
4 1 4
3 1 3