Transport and Storage
6
285616 / 816960300010
2021-11-16·BA00·III·en·00
DE
EN
FR
IT
ES
RU
NL
DK
SE
FI
PT
GR
PL
CZ
SK
HU
SL
RO
BG
LV
LT
EE
CH
KR
CN
Cable entry grommet
Series 8169/1
3.3
Residual Risks
3.3.1 Explosion Hazard
Despite the device's state-of-the-art design, explosion hazards cannot be entirely eliminated
in hazardous areas.
▶
Perform all work steps in hazardous areas with the utmost care at all times!
▶
Transport, store, plan, mount and operate the device exclusively in compliance with the
technical data (see the "Technical data" chapter).
Possible hazards ("residual risks") can be categorized according to the following causes:
Mechanical damage
The components of the cable entry grommet may be damaged during transport, mounting or
commissioning. This kind of damage may, for example, render the device's explosion
protection partially or completely ineffective. This may result in explosions causing serious or
even fatal injury.
▶
Transport the device only in its original packaging or in equivalent packaging.
▶
Check the packaging and the device for damage. Report any damage to R. STAHL
immediately. Do not mount or commission a damaged device.
Improper mounting, installation, commissioning, maintenance or cleaning
Basic work such as mounting, installation, commissioning, maintenance or cleaning of the
device must be performed only in accordance with the applicable national regulations of the
country of use and only by qualified persons. Otherwise, the explosion protection may be
rendered ineffective.
This may result in explosions causing serious or even fatal injury.
▶
Only have mounting, installation, commissioning and maintenance work performed by
qualified and authorised persons (see chapter 3.2).
▶
The cable entry grommet is only intended for fixed installation because a tensile load on
the cable entry is not permitted.
▶
Do not bend or fold the cable entry grommet.
▶
During mounting, the specified parameters must be followed precisely,
especially the drilling diameter, wall thickness, collision frame and tightening torques –
see "Product selection and project engineering". "Mounting and installation" and
"Technical data" chapters.
▶
Prior to commissioning, check the mounting for correctness
(see "Commissioning" chapter).
4
Transport and Storage
▶
Transport and store the device carefully and only in accordance with the safety information
(see "Safety" chapter).
