7
Set Up
1.
Open the shipping carton and carefully remove the unit from the
shipping carton;
2.
Be sure to remove packing material from around the
Haze
machine,
especially near the nozzle;
3.
Set the
Haze
machine on a dry, flat surface;
4.
Use only high quality, water-based fog fluid;
5.
Firmly attach the remote control mechanism to socket (Figure1-G)
on the back of the unit;
6.
Plug mains power cord from the
Haze
machine into appropriate
power supply socket. Wait about 70 seconds for heating element to
heat up;
7.
Refer to your controller manual for operation details;
8.
Moving the machine during operation could probably get air
entered into the liquid pipe and affect smoothness of fog blasts.
If
this happened, press the “Manual Fog” button to fog for a
moment. Until the air is dispersed from the pipe, the machine will
recover its normal fogging.
Very Important:
Please do not pull out the power suddenly when the machine is in
normal smoke condition.
No Fluid Detection
The machine can perform no fluid detection.
Please flip one of the two dip switches to ON in
the picture left to detect the no fluid. When one
of the dip switches is ON, the LED indicator will
light up. When the fluid is run out, the machine
stops working automatically, and LED indicator
will flash indicates no fluid status.
1. Both of the dip switches are OFF, the machine does not detect
whether the fluid is empty, and machine will not stop working
automatically.
