22
Troubleshooting
This troubleshooting guide is meant to help solve simple problems.
If a problem occurs, carry out the steps below in sequence until a
solution is found. Once the unit operates properly, do not carry out
following steps. If the problem persists, refer servicing to a qualified
technician.
Power Connected but No smoke is Emitted:
1.
Check the power supply. Plug the unit into grounded electric power
supply socket with proper voltage;
2.
LCD display is lit and check if it can operate;
3.
The control panel operation is correct;
4.
No fuse breaker is jump off, if any, please press the breaker to do
the reset action;
5.
Check to see if there is enough clean water;
6.
Check whether there is low-fog fluid;
7.
Whether the heater is in the heat (light touch the iron plate next to
the low-fog fluid tank is lukewarm );
8.
Make sure the signal cable polarity is correct and good connection;
9.
Check your DMX address setting.
10.
Check your controller if in correct connection.
Power Connected, Fog Blasts not Smooth:
Should there be no smoke emitted, running noisily or hindered fogging,
pull out the plug immediately. Check if string enough clean water and
low-fog fluid, if there is enough clean water and fluid, plug-in again; still
persists abnormal running, and If causation is unclear, stop running to
avoid any damage, shut down to cool it, and bring unit to your local agent
or appointed service place for inspection, prohibit any dismantlement by
yourself.
