V1.0
Caution: For safety, please read this user manual carefully before initially use!
Safety Instructions:
• Do not open this device, there is no user-serviceable parts inside.
• DO not look at the light source when the device is on.
• CAUTION: This unit's housing may be hot when lights are operating.
• Do not leave any flammable material within 50 cm of this unit while operating or connected to power.
• Use a safety rope when mounting this device overhead.
• Do not operate this device outdoors or where dust, excessive heat, water, or humidity may affect it.
• Do not operate this device if the housing, lenses, or cables appear damaged.
• Do not connect this device to a dimmer or rheostat.
• ONLY connect this device to a grounded and protected circuit.
• ONLY use the hanging bracket to carry this device.
In case of a serious operating problem, stop using immediately.
The maximum ambient temperature is 104° F (40° C). Do not operate this device at higher temperatures.
Power Input & Power Linking
This device has an auto-switching power supply work with input voltage range of 100~240 VAC, 50/60 Hz
Link up to the maximum 16 devices at 120 VAC or 30 at 230 VAC. DO NOT exceed this quantity.
Product Installation
This device can be mounted in many orientations provided each individual device is secured by the use of correct
mounting bracket.Use a safety chain when mounting this device overhead.
Fuse Replacement
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuse holder on the rear panel with a fitting screwdriver from the housing (anticlockwise).
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing and fix it.
USER MANUAL
Pixel Bar
Model No. PIXBAR HEX 6
1/8
V1.0
