Mounting and connecting the camera
Important information:
First connect the camera to your mobile device (see page 25)!
Consider the following when selecting the mounting position of the camera:
Range:
Check whether the connection between the camera and your WLAN router is stable at
the intended mounting position.
Area of coverage:
Angle (approx. 60°) and range (approx. 5 m) of the motion detector.
Lighting conditions:
The camera should not be orientated towards direct, strong light sour-
ces/sunlight, since overexposed images may result.
Power supply:
The camera's power supply unit must not be exposed to the weather in the open!
The plug-in connection of the power supply cable must be protected for preventing any moisture
from entering.
Mounting:
Protection type IP 54 allows devices to be installed in the open. However, the camera
should nevertheless be installed in a well protected place. Make sure that the base material for
mounting is stable and does not give rise to strong vibrations and/or falls.
First, install the camera only provisionally and check whether the desired monitored area is
completely covered prior to drilling the holes for the camera support! Make sure that no cables
or conducts are placed in the wall which may be damaged when drilling!
Mark the desired position for the three drilling holes of the fixing screws by using the camera
support as drilling jig.
Drill the three mounting holes and fix the support using screws which are suitable for the respective
base material.
Afterwards mount the camera.
Plug the power supply unit into a socket (230 V) and connect the plug to the DC IN socket of the
camera.
Technical Data
WiFi frequency
2.412 - 2.462 GHz (channel 1 - 11)
WiFi security
WPA / PSK
WiFi standard
IEEE 802.11b/g/n
Image resolution
720 p(1280 x 720) VGA(640 x 480)
Image sensor
OV9712 CMOS sensor
Objective
3.6 mm/F 2.0
Angle of view (diagonal)
68°
Frame rate
720 p @ 25 fps
Operating voltage
9 V DC/2 A
White balance
automatic
Service temperature range - 20° C ~ 60° C
Protection class
IP 54
Input current
1260 mA with LED (max.) and IR LED, 250 mA without LED a. IR
LED
Dimensions (H x W x D)
80 x 113 x 201 mm
Weight
ca. 390 g incl. support
Disposal instructions
Electric and electronic devices are not to be thrown into the domestic waste. Deliver devices that
are out of order/used with a corresponding collecting point. Please contact your local authorities
for corresponding information.
41
