STA-RITE PCD-10B, Установка, эксплуатация и запасные части

Страница: 2 / 8

2
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety-alert symbol. When you see this symbol on your pump or in
this manual, look for one of the following signal words and be alert to the po-
tential for personal injury.
DANGER warns about hazards that will cause serious personal injury, death or
major property damage if ignored.
WARNING warns about hazards that can cause serious personal injury, death
or major property damage if ignored.
CAUTION warns about hazards that will or can cause minor personal injury or
property damage if ignored.
The label
NOTICE indicates special instructions which are important but not
related to hazards.
Carefully read and follow all safety instructions in this manual and on pump.
Keep safety labels in good condition. Replace missing or damaged safety labels.
OBSERVE THE FOLLOWING
SAFETY PRECAUTIONS
WITH THIS PUMP
Install and use pump according to National Electrical Code and local
codes and ordinances.
Use pump only in a circuit protected by a Ground Fault Circuit
Interrupter (GFCI). Test GFCI before each use. Operation without a
GFCI in circuit can cause dangerous electrical shock hazard.
DO NOT allow anyone, including pump operator, in the water while
pump is standing in water and connected to power source, whether
pump is running or not.
DO NOT modify cord or plug. Plug pump into a 115 volt, 3-prong,
grounded, GFCI protected outlet only. Do not use extension cords.
Do not use as a continuous duty pump for waterfalls, fountains, etc.
Motor may overheat and fail and warranty will be void.
Do not use to pump acid solutions (such as in pool wash work). Pump
casing could be attacked by the acid, causing an electrical shock hazard
and pump failure.
Before each use, carefully inspect power cord for nicks, breaks, and
cracks. If cord shows any visible damage or defects, do not use pump.
Take pump to a qualified repair facility and have cord replaced.
Explosion hazard. Pump is oil filled and must be submerged
while running (see Figure 2) to prevent overheating and possible explosion,
which could cause severe burns and lacerations to anyone nearby.
NOTE: This unit is not designed for applications involving salt water or brine!
Use with salt water or brine will void warranty.
Pump water only with this pump.
Hazardous voltage.
Can shock, burn,
or cause death.
Plug into grounded,
GFCI protected circuit
only.
Read instructions
before using pump.