6
Regulatory compliance information
Formal Notice Required by the U.S. Federal Communications Commission
Responsible party’s contact located in the United States: name: Francesco Doddo; address: STMicroelectronics
Inc, 30 Corporate Drive, Suite 300, Burlington MA, 01803, U.S.A.; e-mail: [email protected]
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Changes or modifications not expressly approved by
the manufacturer could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
•
Standard applied: FCC CFR 47 Part 15 Subpart B. Test method applied: ANSI C63.4 (2014).
Formal Product Notice Required by Industry Canada
Responsible party’s contact located in Canada: name: John Langner; address: STMicroelectronics, Inc., 350
Burnhamthorpe Road West, Suite 303 L5B 3J1, Mississauga, ON, Canada; e-mail: [email protected]
Innovation, Science and Economic Development Canada Compliance
This device complies with Innovation, Science and Economic Development RSS standards. Operation is subject
to the following two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. Changes
or modifications not expressly approved by the manufacturer could void the user’s authority to operate the
equipment.
Conformité à Innovation, Sciences et Développement Économique Canada
Cet appareil est conforme aux normes RSS d'Innovation, Science et Développement économique. L'utilisation
est soumise aux deux conditions suivantes: (1) cet appareil ne doit pas causer d'interférences nuisibles, et (2)
cet appareil doit accepter de recevoir tous les types d’interférence, y comprises les interférences susceptibles
d'entraîner un fonctionnement indésirable. Les changements ou les modifications non expressément approuvés
par le fabricant pourraient annuler le permis d'utiliser l'équipement.
Notice for the European Union
The X-STM32MP-MSP01 is in conformity with the essential requirements of the Directive 2014/53/EU (RED)
and of the Directive 2015/863/EU (RoHS). Harmonized standards applied are listed in the EU Declaration of
Conformity.
Notice for the United Kingdom
The X-STM32MP-MSP01 is in compliance with the UK Radio Equipment Regulations 2017 (UK SI 2017 No.
1206 and amendments) and with the Restriction of the Use of Certain Hazardous Substances in Electrical and
Electronic Equipment Regulations 2012 (UK SI 2012 No. 3032 and amendments). Applied standards are listed in
the UK Declaration of Conformity
UM3076
Regulatory compliance information
UM3076
-
Rev 1
page 33/38
