ST X-NUCLEO-OUT08A1, Руководство пользователя

Страница: 4 / 15

Figure 3. X-NUCLEO-OUT08A1 expansion board: power stage components
For EMC:
•
the transient voltage suppressor (U2), enabled by closing J1, is placed between V
CC
and GND tracks to
protect the IPS160HF against surge discharge on the supply rail path up to ±1 kV/2Ω coupling;
• in common mode surge testing, two single-layer capacitors (C1 and C2 - not included) must be soledered at
the predisposed locations;
• the IPS160HF output stages do not require additional EMC protections with respect to IEC61000-4-2 (± 10
kV contact, ±16 kV air), IEC61000-4-4 (± 4 kV), IEC61000-4-5 (± 3.5 kV) standards.
1.2 Hardware requirements
The X-NUCLEO-OUT08A1 expansion board is designed to be used with the NUCLEO-F401RE or NUCLEO-
G431RB STM32 Nucleo development boards.
To function correctly, the X-NUCLEO-OUT08A1 must be plugged onto the matching Arduino
®
UNO R3 connector
pins on the STM32 Nucleo board as shown below.
UM2715
Hardware requirements
UM2715 - Rev 1
page 4/15