ST X-NUCLEO-OUT08A1, Руководство пользователя

Страница: 6 / 15

Step 8. Push the blue button on STM32 Nucleo board to choose among the examples provided in the default
firmware package.
Note: When using two boards stacked (e.g. dual channel digital output or single channel safety digital output
application), you have to move some signal enabler resistors from DEFAULT to ALTERNATE position. You can
refer to the expansion board schematic and/or to the table below (where board 0 mounts all the resistors in their
DEFAULT position).
Table 1. Pin position when using a board stack
Board 0 Board 1
IN1 Nch_DRV DIAG OUT_FB IN1 Nch_DRV DIAG OUT_FB
R101 R102 R103 R104 R111 R134 R112 R131
UM2715
Board setup
UM2715 - Rev 1
page 6/15