ST X-NUCLEO-OUT01A1, Руководство пользователя

Страница: 9 / 17

UM2209 X-NUCLEO-OUT01A1 expansion board overview
DocID030568 Rev 1 9/17
Figure 5: X-NUCLEO-OUT01A1 expansion board power section components
For EMC:

a Transil™ diode SMC30J30CA is placed on VCC track to protect the ISO8200BQ
against surge discharge

for common mode surge testing, solder two single-layer capacitors C1 and C3 (not
included) at the predisposed locations

22 nF capacitors are included on the output lines for burst disturbance filtering
To supply the load, connect the supply voltage to the J1 2-way screw connector.
The load is connected to the 8-way output.
2.3 Direct access and synchronised access
Supplementary direct access and synchronized access routines are provided to allow
further evaluation of ISO8200BQ IC functionality.
Table 1: ISO8200BQ access modes
Access mode Configuration
Direct access connect the center pin of J4 to GND
Synchronous access connect the center pin of jumper J4 to 3.3 V
Once the selection is configured, push the blue user button on the STM32 Nucleo
development board to begin evaluation.