ST X-NUCLEO-GFX01M Series, Руководство пользователя

Страница: 9 / 31

5.1 Power supply
The X-NUCLEO-GFX01Mx is directly powered by a 3.3 V power supply provided by the Nucleo-64 development
board through pin 16 of the CN2 connector.
5.2 SPI QVGA TFT LCD (LCD1)
5.2.1 Description
The SPI QVGA TFT LCD is connected to a first SPI interface (SPIA) of the STM32 device.
X-NUCLEO-GFX01M1 and X-NUCLEO-GFX01M2 feature each a different LCD with a different controller IC.
Refer to the product history for details.
5.2.2 Operating voltage
The LCD is designed to operate only with a 3.3 V compatible SPI and GPIO interface.
5.2.3 I/O interface
Table 2. X-NUCLEO-GFX01M1 I/O configuration of the LCD
Pin number Pin name Signal name STM32 GPIO Function
1 LED_K4 - - Display backlight LED4 cathode
2 IM0 GND -
System interface selection: 4-line 8-bit data SPI mode
3 IM1 3V3 -
4 IM2 3V3 -
5 IM3 3V3 -
6 RESET DISP_NRESET_PA1 PA1
(1) (2)
Reset active low
7 - 28 - - - Not connected
29 SDO SPIA_MISO_PA6_PB14
PA6
(1)
PB14 (2)
SPI master in/slave out
30 SDI SPIA_MOSI_PA7_PB15
PA7 (1)
PB15
(2)
SPI master out/slave in
31 RD - - Not connected
32 RS/SCL SPIA_SCK_PA5_PB13
PA5
(1)
PB13 (2)
SPI serial clock
33 WR SPIA_DCX_PB3_PB3 PB3 (1) (2) SPI write enable
34 CS SPIA_NCS_PB5_PB5 PB5 (1) (2) SPI chip select active high
35 FMARK DISP_TE_PA0
PA0
(1) (2)
Tearing effect output pin to synchronize MCU on frame
writing
36 VCC 3V3 - 3.3 V power supply
37 GND GND - Ground
38 LED_A 3V3 - Display backlight LED common anode
39 LED_K1 - - Display backlight LED1 cathode
40 LED_K2 - - Display backlight LED2 cathode
41 LED_K3 - - Display backlight LED3 cathode
42 - 45 - - - Not connected
1. STM32 GPIO for NUCLEO-F030R8 , NUCLEO-F070RB , NUCLEO-F072RB , NUCLEO-F091RC , NUCLEO-F401RE ,
NUCLEO-F410RB , NUCLEO-F411RE , NUCLEO-F446RE , NUCLEO-G071RB , NUCLEO-L053R8 , NUCLEO-L073RZ ,
NUCLEO-L452RE and NUCLEO-L476RG .
2. STM32 GPIO for NUCLEO-L412RB-P , NUCLEO-L433RC-P and NUCLEO-L452RE-P .
UM2750
Power supply
UM2750 - Rev 2
page 9/31