ST STM32U575I-EV, Руководство пользователя, Страница: 41 / 105

I/O Hardware Setting (1) Configuration
PB11 SB49 ON
PB11 is used as I2C_SDA to interface the port protection and is
shared with MFX, touch panel, Ext_I2C, EEPROM, 3D accelerometer, 3D
gyroscope, camera, and STMod+.
PB5 (2) JP13
ON
UCPD_DBCC1 is connected to GND for UCPD DB function through the
STM32
OFF
MCU UCPD_DBCC1 is not connected to GND can be used for the
comparator or STMod+.
PB14
(2) JP9
ON
UCPD_DBCC2 is connected to GND for UCPD DB function through the
STM32.
OFF
MCU UCPD_DBCC2 is not connected to GND can be used for TSC
function.
1. The default configuration is in bold.
2. The UCPD DBn function is done by the port protection. The use of PB5 and PB14 to DBn function is only for development
purposes.
7.13.5
USB Type-C
®
connector
Figure 22 shows the pinout of the CN1 USB Type-C
®
connector.
Figure 22. CN1 USB Type-C
®
connector pinout
GND TX1+ TX1- V
BUS
CC1 D+ D- SBU1 V
BUS
RX2- RX2+ GND
GND RX1+ RX1- V
BUS
SBU2 D- D+ CC2 V
BUS
TX2- TX2+ GND
B12 B11 B10 B9 B8 B7 B6 B5 B4 B3 B2 B1
A1 A2 A3 A4 A5 A6 A7 A8 A9 A10 A11 A12
Table 26 describes the pinout of the CN1 USB Type-C
®
connector.
Table 26. CN1 USB Type-C
®
connector pinout
Connector pin
number
STM32 pin Board function
A1 - Power GND
A2 - TX1+ (Not used)
A3 - TX1- (Not used)
A4 - VBUSc: 5V V
BUS
before protection
A5 PA15 CC1: configuration channel 1
A6 PA12 D+: USB data interface differential pair P
A7 PA11 D-: USB data interface differential pair N
A8 -- SBU1 (Not used)
A9 -
VBUSc: 5V V
BUS
before protection
A10 - RX2- (Not used)
A11 - RX2+ (Not used)
A12 - Power GND
B1 - Power GND
B2 - TX2+ (Not used)
STM32U575I-EV
USB Type-C® FS port
UM2854 - Rev 1
page 41/105