UM1667 Rev 3
23/59
UM1667
Hardware layout and configuration
58
Note:
On 4.3-inch daughterboard, BL_CTRL (PA8) can be used to manage on/off of backlight if
needed.
Because BL_CTRL is shared with MII_MCO which is in default setting, R279 must be
removed and R283 must be soldered with a 0 ohm resistor.
The orientation setting of 4.3 inch LCD daughterboard can be changed by hinged standoffs
and pillars. There are two possible orientations according to holes on the motherboard and
LCD daughterboard. Refer to
Figure 4
for details.
Figure 4. Orientation setting of 4.3 inch LCD daughterboard
4.19 Motor
control
The STM32429I-EVAL evaluation board supports both asynchronous and synchronous
three-phase brushless motor control via a 34-pin connector, CN1, which provides all
required control and feedback signals to and from motor power-driving board.
Available signals on this connector include emergency stop, motor speed, 3 phase motor
current, bus voltage, heatsink temperature coming from the motor driving board and 6
channels of PWM control signal going to the motor driving circuit.
Some PCB rework is needed for motor control application to disconnect peripherals which
share I/Os with motor control connector and connect these I/Os to Motor control connector.
•
Remove R219, R214, R211, R227, R283, R279, R256, R261, R102, R104, R243,
R222, R228, R238, R239, R267, R281, R249, SB7, JP4 (no jumper on pin 2-3),
JP15 (no jumper on pin 2-3), JP16.
•
Mount R16, R223, R210, R215, R225, R268, R255, R252, R282, R234, R240, R218,
R232, R242, R235, R263, R292, R280, R246 with 0 ohm resistors.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from