Description of the STEVAL-IFS014V1 (smart monitoring station)
UM0857
26/66
Doc ID 16752 Rev 1
4.3.5
Setting the clock alarm
To set the clock alarm, the user should perform the following steps:
1.
Go to the "SET ALARM TIME" menu using the menu options available (see
2.
The alarm time can be entered using the navigational options like those of the system
time
3.
If the time entered is not a valid time, then an error message is displayed on the screen
and the system exits the menu
4.
If the alarm time entered is valid, then the system alarm is set and a symbol of a clock
alarm is displayed near the displayed time on the sensor data screen (see
).
Figure 20.
Configured clock alarm indication
5.
When the alarm time is reached, an alarm buzzes and a picture of a bell is displayed on
the screen. After a while the default screen (sensor data screen) is again displayed.
6.
The user can reset the alarm (turn the alarm off), at any time by using the "RESET
ALARM" option available in the menu.
Note:
1
The alarm time should always be the greater than the system time by at least 2 seconds.
2
The alarm time can be set only for the same day.
3
The clock alarm feature is available only in the STEVAL-IFS014V1. The clock alarm cannot
be set for any of the nodes.
www.BDTIC.com/ST
