Running the USB to ZigBee dongle evaluation kit
UM0602
12/18
Doc ID 15114 Rev 2
5
Running the USB to ZigBee dongle evaluation kit
First, connect the evaluation board to the PC via the USB cable. As a result, the evaluation
board is enumerated as a STM™ virtual COM port device as shown in
Figure 1
, and is
ready to use.
To access the ZigBee serial control interface of pre-flashed “sink application” demonstration
you need to start Windows HyperTerminal (
Figure 3
) and setup port settings according to
the screenshot here below (
Figure 4
). UART communication speed 115200 kbps, 8 data bits
with no parity and 1 stop bit. Refer to
Section 4.3: Sensor - sink ZigBee application
for more
details about sink node behavior and control.
Figure 3.
Control of sensor - sink demonstration application through Windows HyperTerminal
