ST STEVAL-BCN002V1B, Быстрый старт, Страница: 8 / 17

not needed for
Window 10
Hardware setup: Flash & Debug
8
Step 3
Step 1
Step 2
Connect the USB of the host board to the laptop
Download and install STSW-STM32102
Virtual COM port driver (VCOM)
Download, install, run STSW-BNRGFLASHER
to Flash BlueNRG-2(reference manual UM2406)
Download, install and run STSW-BNRG1STLINK
to Flash BlueNRG-2 (reference manual UM2109)
Connect the USB of the host board to the laptop, also
connect the USB of the Nucleo ST-Link to the laptop
Flash Flash & Debug with supported IDEs
Flasher
in UART
mode
SW2 and SW3 in position 2-3
Host board
If BlueNRG-2 is in deep sleep, it is not possible to Flash & Debug
(use STSW-BNRGFLASHER to Flash - see next slide)
Flash & Debug using supported IDEs (IAR, Keil, Atollic
TrueSTUDIO
) or…