ST 32F411EDISCOVERY, Руководство пользователя, Страница: 14 / 35

Hardware layout UM1842
14/35 DocID027213 Rev 1
4.1.2 Using ST-LINK/V2 to program/debug an external STM32 application
It is very easy to use the ST-LINK/V2 to program the STM32 on an external application.
Simply remove the 2 jumpers from CN3 as shown in
Figure 7
, and connect your application
to the CN2 debug connector according to
Table 3
.
Note: SB13 must be OFF if you use CN2 pin 5 in your external application.
Figure 7. ST-LINK connections image
Table 3. Debug connector CN2 (SWD)
Pin CN2 Designation
1 VDD_TARGET VDD from application
2 SWCLK SWD clock
3 GND Ground
4 SWDIO SWD data input/output
5 NRST RESET of target MCU
6 SWO Reserved
STM32F411VET6