ST Group PIRANHA ST 500, Руководство пользователя

Страница: 9 / 88

ST 500 "Piranha" Operation Manual: General Information
8
1.3.7. TEST SOUND SOURCE
Purpose of the test sound source ( fig.1, 9 ):
 emission of a sound signal (whose correlation with the reception on ST 500 means that
there is an active eavesdropping device nearby making unencoded transmissions)
 forced activation of VOX-activated eavesdropping devices
 location of the detected eavesdropping devices
 creation of a "masking noise" on the site during search operation
 playback from external sources connected through line-in
As the test sound source, an MP3-player/speaker is used. Test sound files are stored on the
USB flash drive ( fig.1 11 ). The user can record sound files of his own making that are better
suited to a given search task. A standard cable is used for charging ( fig.1, 10 ).
1.3.8. MINI-USB CABLE
The cable ( fig.1, 5 ) is used for connecting the main unit to a PC's USB-port.
1.3.9. SPLITTERS, ADAPTERS, AND CONNECTOR CABLES
A set of splitters and connecting cables is supplied with ST 500, that are used for testing
various types of cabling and circuits. Their use is described in Section 5 of this manual:
CONNECTING ST 500 TO CABLING
1.3.10. USB FLASH DRIVE
The USB flash drive contains pre-recorded test sounds for the test sound source, this Manual,
and "ST 500" software .
1.4. POWER SUPPLY
The device is only powered from an inbuilt battery whose charge status is shown in the status
bar ( fig.5, 2 ). A fully charged battery provides 7 hours of non-stop operation.
The battery is charged with the aid of a charger unit ( fig.1, 7 ) plugged into the socket on the
side of the Device ( fig.2, 12 ). The charger is connectable to 220 V/50 Hz mains.
During charging a LED on the side of the Device ( fig.2, 11 ) will be lit red. Full charging time is
up to 7 hours. Upon charging, the LED will change its light to green.
D O N O T A T T E M P T C H A R G I N G T H E D E V I C E D U R I N G O P E R A T I O N !