Hastings Installations and Operations Manual
Page 46
10.
Are there Cycle Time adjustments on the Control Board for different types of fuel?
Answer: There are 4 individual programs on the control board; each
has a different Cycle time.
The Hastings only uses Program 3 and
Program 4
Your Stove has been factory set to Program 3. When programming
the control board, you will see LED light flash, as shown in the
figure to the right. The LED lights flash in the following manner:
1 -
Program 1.
The Cycle Time is 11.5 seconds. THIS PROGRAM
IS ONLY TO BE USED WITH MULTI-FUEL MODELS.
(DO
NOT USE THIS PROGRAM WITH THE HASTINGS).
2 -
Program 2.
The Cycle Time is 13 seconds. THIS PROGRAM IS
ONLY TO BE USED WITH MULTI-FUEL MODELS.
(DO
NOT USE THIS PROGRAM WITH THE HASTINGS
3 -
Program 3.
The Cycle Time is 11.5 seconds.
THIS IS THE
DEFAULT PROGRAM FOR USE WITH THE HASTINGS.
This program is for use with
PFI Premium Pellets.
4 -
Program 4.
The Cycle Time is 10 seconds.
This Program offers
Self-Ignition and is only for units that have the Versa Grate
system & Igniter installed
, used to adjust for variations within the
PFI Premium Pellet Classification.
Program 4 is for adjusting for variations that occur with PFI
Premium Pellets. Ask your dealer before using this Program in your
unit. See page 24 for more information on variations between
different brands of pellets.
12.
How do I change the Programs on the control board?
First the Stove must be turned off and cooled down.
Step 1 - The Thermostat switch must be in the
Manual
position.
Step 2 – Press and hold the
Auger Feed
Button.
Step 3 – Press the
Trim High and Low
Buttons at the same time
and
immediately
release all 3 buttons.
Step 4 – Observe the LED light flashing according to the Program
chosen. Program 1 flashes once, Program 2 flashes twice, Program 3
flashes three times and Program 4 flashes 4 times.
Changing the Cycle Time will change the BTU Input of the Stove. The longer the Cycle time the
lower the BTU rating.
Figure 31
Figure 32
