St. Croix Eclipse-P, Руководство по установке и эксплуатации

Страница: 35 / 65

Eclipse Manual
35
Lighting Your Stove.
WARNING: - Risk of Fire.
-Do not operate with the Firebox door or Ash Removal doors open
-Do not store Fuel or other Combustible material within marked Installation Clearances.
-Inspect and Clean Flues and Chimneys regularly.
Danger: Risk of Fire or Explosion - Do not burn Garbage, Gasoline, Drain Oil or other
Flammable Liquids.
WARNING: Do not bypass the hopper lid switch. The auger can start at any time while the
Stove is running
, this is a high torque motor that is capable of doing SERIOUS harm to
fingers. Keep fingers and other objects away from the auger.
When lighting your Stove for the first time the auger tube will be empty, it helps to hold the
“Auger Button” in until you hear fuel drop into the burn pot.
1. Make sure there is Fuel in the hopper.
2. Press the ON/OFF button once to turn on the Stove.
The Ignition Cycle works as follows:
a. The Combustion Fan comes on at high speed and the control board checks to make sure
the Vacuum Switch locks in.
b. If the board senses the Vacuum Switch after 30 seconds, the Revolution burn pot will
cycle to a clean section and the igniter will come on and pellets will feed for 2 minutes
continuously.
c. After 2 minutes Continuous Feed it switches to the #1 feed setting for the remainder of
the ignition cycle.
d. The igniter runs for 10 minutes and shuts OFF.
e. The stove will continue to feed at the #1 heat level until the Ignition cycle completes after
19 minutes.
f. If Proof of Fire has been reached the unit will enter “Normal Operation Mode”.
If the board still fails to sense the Proof of Fire switch the Stove will go into “Safety Shutdown”
and Flash the #3 LED. (See section on Diagnostic Features on page 39.) If this happens, repeat
the Start-Up process.
Shutting the Stove Off
(Refer to Figure 26)
1. Press the On/Off switch once; the lights will go off and the fire will go out in a few minutes.
The board essentially goes into “Safety Shutdown”.