Remote Access Gateway IGW/941 – Hardware Reference
D o c u m e n t R e v i s i o n 1 . 4
3
1
INTRODUCTION
This document describes the hardware components and the necessary cable connections of
the Remote Access Gateway IGW/941.
1.1
Safety Guidelines
Please read the following safety guidelines carefully! In case of property or personal
damage by not paying attention to this manual and/or by incorrect handling, we do not
assume liability. In such cases any warranty claim expires.
•
The power supply should be in immediate proximity to the device.
•
The power supply must provide a stable output voltage at 24 VDC ± 10%. The out-
put power should be at least 10 W.
•
Please pay attention that the power cord or other cables are not squeezed or dam-
aged in any way when you set up the device.
•
Do NOT turn on the power supply while connecting any cables, especially the pow-
er cables. This could cause damaged device components! First connect the cables
and THEN turn the power supply on.
•
The installation of the device should be done only by qualified personnel.
•
Discharge yourself electrostatic before you work with the device, e.g. by touching a
heater of metal, to avoid damages.
•
Stay grounded while working with the device to avoid damage through electrostat-
ic discharge.
•
The case of the device should be opened only by qualified personnel.
1.2
Conventions
Convention
Usage
bold
Important terms and information
monospace
Filenames, Pathnames, program code, command lines
Table 1:
Conventions used in this document
