Web Application Gateway IGW/935 – First Steps
D o c u m e n t R e v i s i o n 1 . 3
5
3
CONNECTIONS
For a quick and easy start with the IGW/935 there are a few cable connections necessary.
The following chapters describe how these connections have to be made.
3.1
Ethernet Link
The Ethernet link between the PC and
LAN1
of the IGW/935 can be made on two ways:
•
Direct with an Ethernet cross-over cable like shown in
figure 1
.
•
With two standard Ethernet patch cables over a hub or switch like shown in
figure 2
.
Figure 1:
Ethernet link with cross-over cable
Please note:
For the Ethernet connection in
figure 1
it is required to use a
cross-over cable
. Do
not use an ordinary patch cable. Both types of cables are in most cases visual indis-
tinguishable. But the internal wiring is fully different. Mixing up these types of ca-
bles leads to LAN errors. Hence pay attention to the label of the cable or packing.
Figure 2:
Ethernet link with hub or switch
The IP address of the LAN1 interface is ex-factory set to
192.168.0.126
.