Remote Access Gateway IGW/922 - Hardware Reference
B o a r d R e v i s i o n 1 . 0 / M a n u a l R e v i s i o n 1 . 3
9
4.2
Power Supply
The Remote Access Gateway IGW/922 needs a supply voltage of 11 .. 28 VDC to work. Use
the power adapter cable to provide the system with the necessary power like shown in the
figure below.
Figure 3:
Power supply for the Remote Access Gateway IGW/922
Terminal
Signal
A3
Vin (11 .. 28 VDC)
A4
GNDin
Table 6:
Screw terminal power
CAUTION: Providing the Remote Access Gateway IGW/922 with a higher voltage than the
regular 11 .. 28 VDC could cause damaged board components!
CAUTION: Do NOT turn on the power supply while connecting the power adapter cable
with the Remote Access Gateway IGW/922. This could cause damaged board components!
First connect the power adapter cable and THEN turn the power supply on.
