SSV Works GN-3A, Руководство по установке, Страница: 10 / 25

10
A. For this step you will need the sub enclosure mounting plate as well as two (2) M5
screws, two (2) 8mm nuts and four (4) M5 washers. Place the mounting plate on the
factory dash cross member bar behind the glovebox. Match up the holes from the
plate and the bar to insert the M5 screws and washers from top. Use the 8mm nuts
and washers to fasten from underneath.
C. Remove the two (2) bolts on the inside of the glovebox and
replace with two (2) M6 screws and washers.
D. Cut out the LEFT template along the cut line. Position the
template on the fi rewall behind the center dash from the
passenger footwell making sure to line up arrows on the
template to the edges of the panel as seen on image D.
F. Using a scribing tool, mark the center of the three (3) drill
points illustrated on the template as shown on image F.
B. Using a T25 torx driver and 8mm socket, tighten the
screws to secure the plate.
E. Cut out the RIGHT template along the cut line. Position the
template on kick panel in the passenger footwell above the foot
rest making sure to line up arrows on template to the curves of
the panel as seen on image E.
A
C D
F
B
E