![SSR Motorsports GKV200 Скачать руководство пользователя страница 32](http://html.mh-extra.com/html/ssr-motorsports/gkv200/gkv200_owners-manual_1354844032.webp)
61
Engine Oil
Always check and change the engine oil at the intervals outlined in the Periodic Maintenance Chart
beginning on page 58.Oil may need to be changed more frequently if Yours oil is not used. Do not use
automotive oil. see page 99 for the part numbers of Yours products.
Oil Recommendations
These Operating Conditions
Use This Recommended Oil
Outside air temperature is above 32°F/0°
Yours Synthetic Youth Oil(or Synthetic SAE40)
Outside air temperature is below 32°F/0°
Semi-Synthetic 20W-40
NOTICE:
Mixing brands or using a non-recommended oil may cause serious
engine damage. Always use the recommended oil. Never substitute
or mix oil brands.
Oil Check
Maintain the oil level within the safe range on the dipstick.
Do not overfill.
1. Position the vehicle on a level surface.
2. Remove the dipstick. Wipe it dry with a clean cloth.
3. Reinstall the dipstick completely.
4. Remove the dipstick and check the oil level.
Tip: A rising oil level between checks in cool weather driving can indicate
contaminants such as gas or moisture collecting in the crankcase. If the
oil level is over the full/safe mark, change the oil immediately.
5. Add the recommended oil as needed.
6. Reinstall the dipstick.
62
Engine Oil
1. Position the vehicle on a level surface. Set the parking brake.
2. Clean the area around the pre-filter plug.
3. Start the engine. Allow it to idle for two to three minutes.
4. Stop the engine.
Hot oil can cause burns to skin. Do not allow hot oil
to contact skin.
5. Place a drain pan under the engine crankcase.
6. Remove the pre-filter plug. Allow the oil to drain completely.
7. Wash the oil pre-filter screen with solvent to remove debris. Allow the screen to air dry.
8. Clean the pre-filter plug. Install a new sealing washer on the plug. The sealing surfaces on the pug and
crankcase should be clean and free of burrs, nicks or scratches.
9. Reassemble the pre-filter screen and spring to the pre-filter plug
10. Reinstall the pre-filter drain plug. Torque to 11.lbs.(15Nm).
11. Remove the dipstick. Add 30 oz.(0.9 liters)of the recommended oil. Do not overfill. See the specifications
section beginning on page 97 for capacities.
12. Reinstall the dipstick.
13. Start the engine. Allow it to idle for one to two minutes.
14. Stop the engine and inspect for leaks.
15. Check the oil level. Add oil as needed to bring the level to the upper mark on the dipstick.
16. Dispose of used oil properly.