INS-TSSHC-3NPSBFS-16A-1209
8
Temperature set points
The figures beside the word SET indicate the temperature set
points (both in Floor and Ambient modes). They can be dis-
played in degrees Celsius or Fahrenheit (see “Display in degrees
Celsius/Fahrenheit”).
Out of any adjustment mode, press down the + button to in-
crease the set point, or the – button to decrease it. Set points
can only be adjusted by increments of 1 degree. To quickly
scroll through the set point values, press and hold down the but-
ton. Both in manual and automatic modes, the (Ambient) mode
set points can range between 37 to 95°F and can only be ad-
justed by increments of 1°F (from 3 and 35°C; by increments of
1°C from the Celsius mode). From (Floor) mode, the set points
can range between 37 and 82°F (from 3 to 28°C) (if the maxi-
mum floor temperature set is 82°F (28°C)).
In Day mode, you can turn off the thermostat by lowering the
set point below 37°F (3°C). The set point value displayed will be
OFF, and heating system start up will be impossible.
Maximum Floor Temperature Limitation
At any time, the floor temperature (in Floor mode) is maintained
at less than 82°F (28°C) in order to avoid overheating caused by
an excessive heating request, which could damage some ma-
terials or be detrimental for health. It is however possible to in-
crease this limit to 37°C (99°F) by increment of 1°C. To do so,
you must:
1. Press down the A/F button for at least 20 seconds. After 20
seconds, the actual maximum temperature will be displayed
in replacement of the Floor mode set point and will blink
during 5 seconds. Then, you can release the A/F button.
2. Press down the + button to increase this limit or – button to
decrease it.
Regardless of the maximum floor set point (Floor mode), the
maximum Ambient mode set point will always be 35°C (95°F).
