Ss Brewtech Brew Cube, Руководство по эксплуатации продукта

Страница: 4 / 10

Page 4
INSTRUCTIONS
FRAME ASSEMBLY
½” MAX
1. Apply a Silicone Strip to the top surface on each member of the square top Frame (4 strips per
frame). If an additional Plate will be used, also apply a Silicone Strip to each member of the square
bottom Frame.
Note: Top surface has the large corner holes
2. Insert the Threaded Feet through the corner holes on the bottom side of the bottom Frame (oppo-
site the side that has the Silicone Strips applied). The washer on the Threaded Feet should be in
direct contact with the bottom face of the bottom Frame.
Note: 1/2” max distance between the nuts on the base foot
3. If an additional plate will be used, position the countersinks of the Bottom Plate over the large
holes on the bottom Frame.
4. While holding the leg steady, thread the Threaded Feet into the Legs to fasten the Leg and bottom
Frame together. It is recommended to not twist the Legs during assembly to prevent detachment of
the silicone at each end of the Legs. Wait to fully tighten the Threaded Feet until step 9.
←
←