( 3 / 8)
Front panel:
Rear panel:
Device in use / service:
By default, Power LED indicates the device is on main power. When the Power
LED is off, check the main power input.
The unit can be supplied with AC85-264V or AC/DC battery power. There is no
polarity restriction for this port. AC or DC power with 12-24V can be used.
When the DMX cable is connected to the device, the LEDs marked as D+ and D-
go on for the side marked as DMX input, thru and this indicates that the DST4W-
PRO is receiving the DMX signal. Blinking frequency of these LEDs also indicates
refresh rate of the DMX signal. Fast blinking – high refresh rate, slow blinking –
low refresh rate.
On the rear panel of the DST4W-PRO, there are outputs A-D, which are
retransmitting the input to the optically isolated outputs. If any of the data LEDs
is off, unplug the signal cable corresponding to this output and check the cable
for short circuit between D+ and CMN or D- and CMD lines.
