SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
IMPORTANT SAFETY INFORMATION
The following general safety precautions have to be observed during all phases of
operation, service, and the repair of this equipment. Failure to comply with these
precautions or with specific warnings in this manual violates safety standards of
design, manufacture, and the intended use of this equipment.
Do not operate in an explosive atmosphere!
Do not operate this equipment in the presence of flammable gases or fumes.
Operation of any electrical instrument in such an environment constitutes
a definite safety hazard. Device should be never placed near or over a heat
register or other source of heated air and it should not be installed or operated
without proper ventilation.
Mains 85-265V connection
AC power is connected to the splitter via Neutrik PowerCon blue connector.
Standard supply is UNISCHUKO lead with Neutrik PowerCon. Always respect the
markup of L and N on connectors for correct wiring of Line and Neutral.
DMX 512 / W-DMX port
USITT DMX 512 (1990) output protected with TRANSIL diodes
Pin Connection on the 5-pin XLR plug:
Pin 1:
GND
Pin 2:
DMX -
Pin 3:
DMX +
Pins 4, 5:
Not connected
W-DMX interface:
Compatible with wirelesdmx.com and W-DMX TX devices made by SRS
RS232 interface:
RX/TX + RTS/CTS
RS422 interface:
RX line pair
TX line pair
USB interface:
•
FTDI with XP/w7/w8 compatibility
•
Firmware upgrade port
•
Settings upgrade port
