SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
Front panel:
Rear panel:
Device in use / service:
By default, Power LED indicates the device is on main power. When the Power LED
is off, check the main power input.
When the DMX cable is connected to the device, LEDs marked as D+ and D- go on
for the side marked as DMX input, thru and this indicates that DST4 is receiving
the DMX signal. Speed of light on these LEDs also indicates the refresh rate of
DMX signal. Fast blinking – high refresh rate, slow blinking – slow refresh rate.
On the rear panel of DST4, there are outputs A-D, which are retransmitting the
input to the optically isolated outputs. If there of data LEDs is off, unplug the signal
cable corresponding to this output and check the cable for short circuit between
D+ and CMN or D- and CMD lines.
