SRS Light Design s.r.o
, Rybničná 36/D , 831 06 Bratislava, Slovak Republic
tel:+421244681417, fax:+421244681419,
www.srslight.com
,
Front panel:
Rear panel:
Device in use / service:
By default Power LED indicates the device is on main power. Unit should be powered from
the Mains AC85-230V switching power supply or from battery connected to the AC/DC
screw terminal. Maximum input voltage on battery is in range 12-24V. When there isn’t
power light please check main power input. When this not help please call service first
and then open DST4 and check fuses on main board.
When there is connected the DMX cable to device, LEDs marked as D+ and D- goes ON for
side marked as DMX input, thru and this indicates that DST4 is receiving the DMX signal.
Speed of light on these LEDs also indicates refresh rate of DMX signal. Fast blinking –
high refresh rate, slow blinking – slow refresh rate.
On rear panel of DST4 you can see outputs A-D which are retransmitting the input to the
optically isolated outputs. If there is any of data LEDs off, unplug the signal cable
corresponding to this output and check the cable for short circuit between D+ and CMN or
D- and CMD lines. If there is any problem just send us an email to
or
call us to +421244681417 and be calm because we help you to fix your problems for sure.
