SRS Labs SR640 Series, Руководство пользователя

Страница: 12 / 20

10
face driver must all be configured properly. To con-
figure theSR640, the GPIB address must be prop-
erly set using the DIP switch on the back panel.
The SR640 is shipped with the GPIB address set
to 23.
Make sure that you follow all the instructions for in-
stalling the GPIB card. The National Instruments
card cannot simply be unpacked and put into your
computer. To configure the card you must first set
jumpers and switches to set interrupt levels and I/
O addresses. You must then run the program IB-
CONF to configure the DOS resident GPIB driver.
Please refer to the National Instruments manuals
for complete details.
Once all the hardware and software has been con-
figured properly, try using the IBIC program sup-
plied with the National Instruments card to send
commands and receive data from the SR640. If
you cannot talk to the SR640 with the IBIC pro-
gram, there is no point in trying to write a program.
Although the National Instruments language con-
tains many commands, to avoid confusion it is
best to start with a few simple ones. Use IBWRT
and IBRD to write and read from the SR640. After
you are familiar with the simple commands you
can explore other, more complex, programming
commands.
Guide to Programming
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com