( 3 / 4)
Controls and indication
1.
Power indication
2.
DMX input signalization
3.
DMX input connector channel A
4.
DMX Termination switch 120R + signalization LED
5.
RDM filter signalization LED
6.
DMX data output signalization for positive and negative signal
7.
DMX output connector
Device Design
Front panel:
Rear panel:
Device use/servicing:
The Power LED indicator indicates the device is on the main power. All other DATA indication
LEDs being off mean no incoming signal. The termination red LEDs are ON when the termination
switch is activated. Each DMX source is retransmitted to the ten outputs. When there are
connected the RDM devices without RDM support turn the RDM filter on by switch. This is
indicated with the GREEN LED close to the switch.
When the DMX cable is connected to the device, all LEDs marked with symbols D+/D- or the sign
of signal polarity go ON. This indicates that DSR10-RDM is functioning properly and is
retransmitting the input to the outputs. If any of LEDs is off, check the cable first – short circuit
on a line causes the respective LED is off.
Device is upgradeable via USB to DMX cable. Ask on
for more details.