SRS Labs ADR24-DIGI-AHD, Инструкция по эксплуатации, Страница: 3 / 18

( 3 / 18)
Operation
The ADR-DIGI-AHD is manufactured from as 24/36/48 channels and it suits as directional remote for
digital controllers. The ADR-DIGI-AHD Motors/Hoists connected to the GMDseries and AHDseries
controller can be activated individually or simultaneously using the GO button located on the ADR-
DIGI-AHD cable. Unit is also equipped with LCD display and encoder wheel with buttons to simplify
setup and operation of system.
How to start

Connect a 5-pin NC5MXX plug to the remote input of the ADR-DIGI-AHD unit.

Check if the emergency STOP button on both AHD devices is released. If not, this state will
be indicated by the STATUS LED blinking in red color. Check STOP buttons on all connected
controllers. Rotate them clockwise to release and RESET units

Move the lever on ADR-DIGI-AHD corresponding to each motor to the desired position.
According to the position of lever, hoists act as follows:
o
UP - Lever in upper position
o
STAY – Lever in middle position
o
DOWN - Lever in lower position

Pushing the GO button will activate the motors and move them simultaneously.

Releasing the GO button will stop the movement of the motors simultaneously.

When the device is not in use, it is highly recommended to push E-STOP mushroom or TURN
off units via key on front panel of AHD controller
To Move a Single Motor:

Set the UP/DOWN toggle switch for desired motor to the desired direction. The associated
LED will illuminate green for UP and red for DOWN direction.

Hold the GO button until the motor(s) is/are moved to the desired height, then release.
To Move Several Motors:

Set the UP/DOWN toggle switches for each motor to the desired direction. The associated
LEDs will illuminate green for UP and red for DOWN direction.

Hold the GO button until the motors are moved to the desired height, then release.